AIR FUEL RATIO SENSOR (w/ DPF) INSTALLATION


  1. INSTALL AIR FUEL RATIO SENSOR


    1. Using SST, install the air fuel ratio sensor to the front exhaust pipe.

      SST
      09224-00010
      Torque:
      without SST
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }
      with SST
      39 N*m  { 398 kgf*cm, 29. ft.*lbf }

      Tech Tips


      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification Click here.

      • Make sure SST and the wrench are connected in a straight line.

    2. Connect the air fuel ratio sensor connector and engage the wire harness clamp.

      Tech Tips

      Make sure that the part of the wire harness labeled A is as shown in the illustration.