ECD SYSTEM (w/ EGR Cooler Bypass Valve), Diagnostic DTC:P0516, P0517

DTC Code DTC Name
P0516 Battery Temperature Sensor Circuit Low
P0517 Battery Temperature Sensor Circuit High

DESCRIPTION

The battery thermometer sensor is installed on the battery negative terminal to detect battery temperature.

A thermistor is integrated into the battery thermometer sensor, and the resistance of the thermistor in the battery thermometer sensor changes according to the battery temperature.

The resistance of the thermistor in the battery current sensor decreases as the battery temperature increases. The resistance increases as the temperature decreases.

The battery thermometer sensor is connected to the ECM. The ECM supplies 5 V from the THB terminal to the battery thermometer sensor through resistor R.

The battery thermometer sensor and resistor R are connected in series. This results in changes in the voltage supplied from the THB terminal when the resistance changes according to the battery temperature.

The ECM determines the battery temperature according to changes of voltage. When the battery temperature is high, the ECM determines to reduce the amount of current supplied from the generator assembly in order to protect the battery.

A01KFGXE01
DTC No. DTC Detection Condition Trouble Area
P0516

Battery thermometer sensor output value is 0.2 V or less for 0.5 seconds or more with the ignition switch ON

(1 trip detection logic)

  • Battery thermometer sensor

  • Short in battery thermometer sensor circuit

  • ECM
P0517

Battery thermometer sensor output value is 4.8 V or more for 0.5 seconds or more with the ignition switch ON

(1 trip detection logic)

  • Battery thermometer sensor

  • Open in battery thermometer sensor circuit

  • ECM

WIRING DIAGRAM

A01KEH6E06

INSPECTION PROCEDURE

Note

After replacing the ECM, the new ECM needs registration Click here and initialization Click here.

Tech Tips

If DTCs relating to different systems are output, and they share terminal E2 as their ground, check this ground circuit first.

PROCEDURE


  1. INSPECT BATTERY THERMOMETER SENSOR (BATTERY TEMPERATURE SENSOR)


    1. A01KHW7E08
      Text in Illustration
      *1 Battery Thermometer Sensor
      *a Component Side

      Disconnect the B8 battery thermometer sensor connector.

    2. Measure the resistance of the battery thermometer sensor.

      Standard resistance
      Tester Connection Condition Specified Condition
      1 - 2 20 to 30°C (68 to 86°F) 1.91 to 2.05 kΩ

    3. Reconnect the battery thermometer sensor connector.


    NG

    REPLACE BATTERY THERMOMETER SENSOR (BATTERY TEMPERATURE SENSOR)

    OK

  2. CHECK HARNESS AND CONNECTOR (BATTERY THERMOMETER SENSOR (BATTERY TEMPERATURE SENSOR) - ECM)


    1. Disconnect the B8 battery thermometer sensor connector.

    2. Disconnect the E12 and E13 ECM connectors.

    3. Check the resistance.

      Standard resistance (Check for open)
      Tester Connection Specified Condition
      B8-1 - E13-1 (THB) Below 1 Ω
      B8-2 - E12-14 (E2) Below 1 Ω
      Standard resistance (Check for short)
      Tester Connection Specified Condition
      B8-1 or E13-1 (THB) - Body ground 10 kΩ or higher
      B8-2 or E12-14 (E2) - Body ground 10 kΩ or higher

    4. Reconnect the battery thermometer sensor connector.

    5. Reconnect the ECM connectors.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE ECM Click here