REAR DIFFERENTIAL CARRIER ASSEMBLY REMOVAL


  1. DRAIN DIFFERENTIAL OIL


    1. A01CH8OE01

      Using a socket wrench (21 mm), remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and drain the oil.

    3. Install the drain plug with a new gasket.

      Torque:
      50 N*m  { 510 kgf*cm, 37 ft.*lbf }

  2. REMOVE REAR AXLE SHAFT

    Tech Tips

    REAR AXLE SHAFT (See Pub. No. RM1008E)

  3. SEPARATE PROPELLER SHAFT ASSEMBLY


    1. A01CIEIE01

      Put matchmarks on the flanges.

    2. Remove the 4 nuts and 4 bolts, and separate the propeller shaft assembly.

      Note

      Hang the propeller shaft assembly using wire. Be careful not to apply excessive force to the joint of the propeller shaft assembly.

      Tech Tips

      If the flange is engaged firmly, lightly tap it to remove using a plastic hammer.

  4. REMOVE REAR DIFFERENTIAL CARRIER ASSEMBLY


    1. A01CHV8E01

      Using a jack, support the differential carrier assembly.

      Note

      As it is heavy, support the differential securely with a jack.

    2. Remove the 8 bolts, 4 nuts and 4 washers, and tighten the 2 bolts (M10 x P1.25) into the 2 screw holes evenly to remove the differential carrier assembly.

      Note

      Be careful not to damage the installation surface.

  5. REMOVE REAR DIFFERENTIAL CARRIER GASKET


    1. Remove the rear differential carrier gasket.