REAR DIFFERENTIAL CARRIER OIL SEAL INSTALLATION


  1. INSTALL REAR DIFFERENTIAL CARRIER OIL SEAL


    1. A01CI9A

      Apply MP grease to the lip of a new oil seal.

    2. Using a brass bar and hammer, tap in the oil seal.

      Oil seal drive in depth
      0 mm (0 in.)

      Note

      Be sure to tap the rear differential carrier oil seal uniformly so that it is not installed at an angle.

  2. INSTALL REAR DRIVE PINION COMPANION FLANGE SUB-ASSEMBLY


    1. Install the rear drive pinion companion flange sub-assembly on the drive pinion.

    2. A01CJ1V

      Temporarily install the 2 nuts to the bolts on the rear drive pinion companion flange sub-assembly.

    3. Fix the rear drive pinion companion flange sub-assembly with the tire lever. Using a deep socket wrench (41 mm), install a new rear drive pinion nut.

      Torque:
      435 N*m  { 4437 kgf*cm, 321 ft.*lbf }

      Note

      Ensure to install the 2 nuts so as not to break the bolt of the rear drive pinion companion flange sub-assembly.

    4. Remove the 2 nuts and the 2 bolts.

  3. INSTALL REAR DRIVE PINION NUT


    1. A01CGOIE01

      Using SST and a hammer, stake a new rear drive pinion nut.

      SST
      09930-00010

      Note


      • Ensure that there is no crack on the staked part of the rear drive pinion nut.

      • Stake the nut completely as shown in the illustration.

  4. INSTALL PROPELLER SHAFT ASSEMBLY


    1. A01CIEIE01

      Align the matchmarks and install the propeller shaft assembly to the rear drive pinon companion flange sub-assembly with the 4 nuts and 4 bolts.

      Torque:
      75 N*m  { 760 kgf*cm, 55 ft.*lbf }

  5. ADD DIFFERENTIAL OIL


    1. Add oil.

      Capacity
      5.2 liters (5.5 US qts, 4.6 Imp. qts)
      Oil grade
      Hypoid gear oil API GL-5 or equivalent
      Recommended oil viscosity
      SAE 90