MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL REMOVAL


  1. DRAIN MANUAL TRANSMISSION OIL


    1. Remove the filler plug and gasket.

    2. Remove the drain plug and gasket, and then drain the manual transmission oil.

    3. Install a new gasket and the drain plug.

      Torque:
      39 N*m  { 400 kgf*cm, 29 ft.*lbf }

  2. REMOVE PROPELLER SHAFT ASSEMBLY

    Click here.

  3. REMOVE MANUAL TRANSMISSION OUTPUT SHAFT REAR SET NUT


    1. A01CH0V

      Using a chisel and a hammer, release the staked part of the transmission output shaft rear set nut.

    2. Pull the parking brake lever fully, and shift into the reverse position.

    3. A01CHRW

      Using a 36 mm socket wrench, remove the transmission output shaft rear set nut.

    4. Using a screwdriver, remove the O-ring.

  4. REMOVE PARKING BRAKE DRUM SUB-ASSEMBLY


    1. A01CID4

      Remove the bolt and dust cover from the parking brake drum.

    2. Release the parking brake lever.

    3. Remove the parking brake drum sub-assembly and companion flange.

    4. A01CJER

      If the brake drum cannot be removed easily, turn the shoe adjuster in the direction of the illustrated arrow mark until the drum turns freely.

  5. REMOVE PARKING BRAKE PLATE SUB-ASSEMBLY


    1. A01CI7A

      Remove the 4 nuts and disconnect the parking brake plate sub-assembly.

      Tech Tips

      Use wire or an equivalent tool to keep the parking brake plate sub-assembly from hanging down by the parking brake cable.

  6. REMOVE MANUAL TRANSMISSION EXTENSION HOUSING OIL SEAL


    1. A01CH1YE01

      Using SST, remove the oil seal.

      SST
      09308-00010