OIL PUMP INSTALLATION


  1. INSTALL OIL PUMP ASSEMBLY


    1. A01CGT5E04
      Text in Illustration
      *a Apply Engine Oil

      Apply engine oil to the pump case of the cylinder block sub-assembly and the bearing.

      Note

      Failure to apply engine oil to the pump case may cause poor lubrication, resulting in burning engine oil or abnormal engine wear.

    2. Install a new gasket.

    3. Install the oil pump assembly with the 7 bolts.

      Torque:
      29 N*m  { 291 kgf*cm, 21 ft.*lbf }

  2. INSTALL NO. 1 IDLE GEAR SUB-ASSEMBLY


    1. Install the No. 1 idle gear sub-assembly and No. 1 idle gear thrust plate to the No. 1 idle gear shaft.

    2. A01CHCFE03
      Text in Illustration
      *1 No. 1 Idle Gear Shaft
      *2 Oil Hole
      *3 Alignment Mark

      With the No. 1 idle gear shaft oil hole facing down, match the alignment marks for each gear, and insert the No. 1 idle gear shaft with No. 1 idle gear sub-assembly into the cylinder block sub-assembly.

      Note

      If the oil hole is not facing down, it will cause engine seizure or abnormal engine wear.

    3. Install the No. 1 idle gear sub-assembly with the bolt.

      Torque:
      137 N*m  { 1397 kgf*cm, 101 ft.*lbf }

  3. INSTALL CAMSHAFT

    Click here