GLOW PLUG INSTALLATION

INSTALL GLOW PLUG ASSEMBLY

1. Using a 12 mm deep socket wrench, install the 4 glow plug assemblies.

   Torque:

   23 N*m  { 229 kgf*cm, 17 ft.*lbf }

INSTALL GLOW PLUG GROUND WIRE

1. 

   Text in Illustration

   *1	Wire Harness
   *2	Glow Plug Ground Wire
   	Engine Front Side

   Install the 3 glow plug ground wires so that they overlap as shown in the illustration. Make sure that the glow plug ground wire on the front side of the engine is installed first.

   Note

   If the glow plug ground wires are not installed in the correct order, they may become deformed when the nuts are tightened.

2. Install the wire harness to the No. 4 glow plug.

3. Install the 4 nuts.

   Torque:

   1.3 N*m  { 13 kgf*cm, 11 in.*lbf }

   Note

   Check that the glow plug ground wires do not interfere with the cylinder head or intake manifold.

4. Install the 4 screw grommets.

INSTALL ENGINE REAR SIDE SHUTTER

1. Install the engine rear side shutter with the 4 bolts.

CONNECT CABLE TO NEGATIVE BATTERY TERMINAL