ENGINE OIL COOLER INSTALLATION


  1. INSTALL OIL COOLER ASSEMBLY


    1. A01CH3V

      Install the oil cooler assembly and 2 new gaskets to the oil filter bracket sub-assembly with the 4 nuts.

      Torque:
      12 N*m  { 125 kgf*cm, 9.0 ft.*lbf }
    2. A01CJ4BE01

      Apply a continuous bead of seal packing (diameter 1.5 to 2.5 mm (0.06 to 0.10 in.)) as shown in the illustration.

      Seal packing
      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent.

      Note


      • Remove any oil from the contact surface.

      • Install the oil cooler within 3 minutes of applying the seal packing.

      • Do not start the engine for at least 2 hours after the installation.

    3. A01CGSY

      Install the oil cooler assembly with oil filter bracket with the 15 bolts.

      Torque:
      29 N*m  { 290 kgf*cm, 21 ft.*lbf }

  2. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY


    1. A01CHFVE01

      Install the oil pressure switch.


      1. Install the oil pressure switch with a new O-ring by hand, then further tighten it by 20 to 40° as shown in the illustration.

    2. Connect the oil pressure switch connector.

  3. INSTALL OIL FILTER ASSEMBLY


    1. Clean the oil filter installation surface.

    2. Apply engine oil to the oil filter gasket.

    3. Lightly screw the oil filter to the engine until the oil filter does not turn.

    4. Using SST, tighten the oil filter an additional 2/3 turn.

      SST
      09228-78010

  4. INSTALL TURBOCHARGER SUB-ASSEMBLY

    Click here