OIL AND OIL FILTER REPLACEMENT

CAUTION:


  • Prolonged and repeated contact with engine oil will cause the loss of natural oils from the skin, leading to dryness, irritation and dermatitis. In addition, used engine oil contains potentially harmful contaminants that may cause skin cancer.

  • Precautions should be taken when replacing engine oil to minimize the risk of your skin making contact with used engine oil. Wear protective clothing and gloves. Wash your skin thoroughly with soap and water, or use a waterless hand cleaner to remove any used engine oil. Do not use gasoline, thinners or solvents.

  • For environmental protection, used oil and used oil filters must be disposed of at designated disposal sites.


  1. DRAIN ENGINE OIL


    1. Remove the oil filler cap sub-assembly.

    2. Remove the drain plug from the oil pan and drain engine oil into a container.

    3. Clean the drain plug.

    4. Install the drain plug with a new gasket.

      Torque:
      41 N*m  { 418 kgf*cm, 30 ft.*lbf }

  2. REMOVE OIL FILTER SUB-ASSEMBLY


    1. Using SST, remove the oil filter.

      SST
      09228-78010

  3. INSTALL OIL FILTER SUB-ASSEMBLY


    1. Clean the oil filter installation surface.

    2. Apply engine oil to the oil filter gasket.

    3. Lightly screw the oil filter to the engine until the oil filter does not turn.

    4. Using SST, tighten the oil filter an additional 2/3 turn.

      SST
      09228-78010

  4. ADD ENGINE OIL


    1. Add fresh oil and install the oil filler cap sub-assembly.

      Engine oil
      Oil Grade Oil Viscosity (SAE)

      • API CD, CE, CF, CH-4, or CI-4 (You may also use API CE, or CD.)

      • 10W-30

      • 20W-20

      • 15W-40

      • 30

      • 40
      Capacity
      Item Fill amount
      Drain and refill with oil filter change 7.2 liters (7.6 US qts, 6.3 Imp. qts)
      Drain and refill without oil filter change 6.2 liters (6.6 US qts, 5.5 Imp. qts)
      Dry fill 8.9 liters ( 9.4 US qts, 7.8 Imp. qts)

  5. INSPECT FOR OIL LEAK


    1. Warm up the engine and check for engine oil leaks.

  6. CHECK OIL LEVEL


    1. A01CH5VE01

      Warm up the engine, then stop the engine and wait 5 minutes. Check that the engine oil level is between the Low and Full level marks.

      If low, check for leakage and add oil up to the full level mark.

      Note


      • Do not add engine oil above the Full mark.

      • If the oil level is 25 mm (0.98 in.) above the Full mark, replace engine oil.