FUEL TANK INSTALLATION


  1. INSTALL FUEL TANK VENT TUBE SUB-ASSEMBLY


    1. A01CIKN

      Install the fuel tank vent tube sub-assembly and a new gasket with the 5 bolts.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

  2. INSTALL FUEL CUT OFF VALVE ASSEMBLY


    1. A01CJ9U

      Install the 2 fuel tank support tube plates, the 2 fuel cut off valve assemblies and 4 new gaskets with the 10 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }
    2. A01CJ0E

      Install the evaporation hose with the 2 clips and clamp.

  3. INSTALL FUEL SENDER GAUGE ASSEMBLY


    1. A01CGSG

      Install the fuel sender gauge assembly and a new gasket with the 5 screws.

      Torque:
      1.5 N*m  { 15 kgf*cm, 13 in.*lbf }

  4. INSTALL FUEL TANK ASSEMBLY


    1. A01CHS7E01

      While supporting the fuel tank, connect the fuel sender gauge connector.

    2. Install the fuel tank bands and the fuel tank stays with the 12 nuts and 8 bolts.

      Torque:
      61 N*m  { 622 kgf*cm, 45 ft.*lbf, for bolt }
      13 N*m  { 130 kgf*cm, 9 ft.*lbf, for nut A }

  5. CONNECT FUEL EVAPORATIVE SEPARATOR FUEL HOSE


    1. A01CGSH

      Install the fuel evaporative separator fuel hose with the clip and clamp.

  6. CONNECT NO. 2 RETURN TUBE FUEL HOSE


    1. A01CHOO

      Install the No. 2 return tube fuel hose with the clip.

  7. CONNECT NO. 2 MAIN TUBE FUEL HOSE


    1. A01CI42

      Install the No. 2 main tube fuel hose with the clip.

  8. ADD FUEL

  9. BLEED AIR FROM FUEL SYSTEM


    1. A01CGS9

      Loosen the fuel filter's air bleed plug.

      Note


      • Do not use any tools.

      • Do not allow any fuel to spill.

      • If any fuel spills on any part of the engine, wipe it clean with a shop rag or a piece of cloth.

    2. A01CGKM

      While covering the drain pipe with a shop rag or a piece of cloth, press and release the priming pump until the fuel from the drain pipe does not have any bubbles.

    3. A01CIWK

      Tighten the air bleed plug.

      Note

      Do not use any tools.

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  11. INSPECT FOR FUEL LEAK


    1. Perform the Active Test.


      1. Connect the intelligent tester to the DLC3.

      2. Start the engine.

      3. Turn the intelligent tester on.

      4. Select the following menu items: Powertrain / Engine / Active Test.

      5. Perform the Active Test.

        Intelligent Tester Display Test Details Control Range Diagnostic Notes
        Test the Fuel Leak Fuel leaks (common rail internal fuel pressure is raised) Stop/Start

        • Fuel pressure inside common rail pressurized to specified value and engine speed increased to 2000 rpm when Start is selected.

        • Above conditions preserved while Start is selected.

  12. PERFORM INITIALIZATION

    Tech Tips

    Click here.