DRIVE BELT INSTALLATION


  1. INSTALL NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT


    1. Install the No. 1 V (cooler compressor to crankshaft pulley) belt.

  2. ADJUST NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT


    1. A01CHHDE01

      Turn bolt B to adjust the tension of the No. 1 V (cooler compressor to crankshaft pulley) belt.

    2. Tighten bolt A.

      Torque:
      44 N*m  { 449 kgf*cm, 32 ft.*lbf }

    3. Tighten bolt B.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    4. Check that the V belt fits properly into the grooves.

      Tech Tips

      Confirm by hand that the No. 1 V (cooler compressor to crankshaft pulley) belt has not slipped out of the grooves on the bottom of the pulley.

  3. INSTALL FAN AND GENERATOR V BELT


    1. Install the fan and generator V belt.

  4. ADJUST FAN AND GENERATOR V BELT


    1. A01CI02E01

      Turn bolt C to adjust the tension of the fan and generator V belt.

    2. Tighten bolts A and B.

      Torque:
      55 N*m  { 561 kgf*cm, 41 ft.*lbf }

    3. Tighten bolt C.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    4. Check that the V belt fits properly into the grooves.

      Tech Tips

      Confirm by hand that the fan and generator V belt has not slipped out of the grooves on the bottom of the pulley.

  5. INSPECT DRIVE BELT

    Click here