FRONT CRANKSHAFT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL


    1. A01CHH5E01

      Using SST and a hammer, tap in a new oil seal to the timing gear case so that the oil seal is flush with the timing gear edge.

      SST
      09223-78010

      Note


      • Be careful not to tap the oil seal at an angle.

      • Keep the gap between the gear case edge and the oil seal free of foreign matter.

    2. Apply MP grease to the oil seal lip.

  2. INSTALL CRANKSHAFT PULLEY


    1. Install the pulley and spacer to the crankshaft.

      Tech Tips

      Align the pulley set key with the key groove of the pulley.

    2. Step 1


      1. Using a 46 mm socket wrench, tighten the nut.

        Torque:
        100 N*m  { 1020 kgf*cm, 74 ft.*lbf }

        Tech Tips

        Insert a screwdriver through the inspection hole of the flywheel housing into the ring gear of the flywheel to keep it from turning together with the crankshaft.

    3. Step 2


      1. A01CHGIE01
        Text in Illustration
        *1 Paint Mark
        A01CHW8 RH

        Mark the RH of each crankshaft pulley bolt head with paint.

      2. Further tighten the bolts 90° as shown in the illustration.

      3. Check that the paint mark are now at a 90° angle to the RH.

  3. INSTALL NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT (w/ Air Conditioning System)


    1. Install the No. 1 V (cooler compressor to crankshaft pulley) belt.

  4. ADJUST NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT (w/ Air Conditioning System)


    1. Turn the bolt (B) to adjust the tension of the V belt.

    2. Tighten the bolt (A).

      Torque:
      44 N*m  { 450 kgf*cm, 33 ft.*lbf }

    3. Tighten the bolt (B).

      Torque:
      5.9 N*m  { 60 kgf*cm, 52 in.*lbf }

    4. Check that the belt fits properly into the grooves.

      Tech Tips

      Confirm by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  5. INSTALL RADIATOR ASSEMBLY

    Click here