CYLINDER BLOCK REPLACEMENT


  1. REPLACE STRAIGHT PIN

    Note

    It is not necessary to remove the straight pins unless they are being replaced.


    1. Remove the 7 straight pins.

    2. Using a plastic-faced hammer, tap in 7 new straight pins.

      Standard Protrusion Height
      Item Specified Condition
      A 6.0 mm (0.236 in.)
      B 13.0 mm (0.512 in.)
      C 16.0 mm (0.630 in.)
      D 6.0 mm (0.236 in.)
      A01CHVHE03
      Text in Illustration
      *a Front Side *b Rear Side
      *c Cylinder Head Side *d Protrusion Height