ENGINE REAR OIL SEAL INSTALLATION


  1. INSTALL REAR ENGINE OIL SEAL


    1. A01CJ94E01

      Using SST and a hammer, tap in a new oil seal until it is 4 mm (0.16 in.) below the upper edge of the flywheel housing.

      SST
      09223-78010

      Note


      • Be careful not to tap the oil seal at an angle.

      • Keep the gap between the rear oil seal retainer edge and the oil seal free of foreign matter.

    2. Apply MP grease to the oil seal lip.

  2. INSTALL FLYWHEEL SUB-ASSEMBLY


    1. A01CHUK

      Insert the flywheel slowly until it contacts the collar knock in order to prevent impact on the guide bar. Adjust the position, then insert it completely.

    2. Apply clean engine oil to the threads of the flywheel bolts and the flywheel bolt seats.

    3. Tighten the flywheel bolts in the order shown in the illustration.

      Tech Tips

      Insert a screwdriver through the inspection hole of the flywheel housing into the ring gear of the flywheel to keep it from turning together with the crankshaft.

      Torque:
      190 N*m  { 1938 kgf*cm, 140 ft.*lbf }

  3. INSTALL CLUTCH DISC ASSEMBLY

  4. INSTALL CLUTCH COVER ASSEMBLY

  5. INSTALL MANUAL TRANSMISSION ASSEMBLY