DRIVE BELT INSTALLATION


  1. INSTALL FAN & GENERATOR V BELT


    1. Install the belt.

  2. ADJUST FAN & GENERATOR V BELT


    1. A01CI02E01

      Turn bolt C to adjust the tension of the V belt.

    2. Tighten bolts A and B.

      Torque:
      Bolt A
      29 N*m  { 290 kgf*cm, 18 ft.*lbf }
      Bolt B
      55 N*m  { 560 kgf*cm, 38 ft.*lbf }

    3. Tighten bolt C.

      Torque:
      6.0 N*m  { 60 kgf*cm, 53 in.*lbf }

    4. Check that the belt fits properly into the grooves.

      Tech Tips

      Confirm by hand that the belt has not slipped out of the grooves on the bottom of the pulley.

  3. INSPECT DRIVE BELT


    1. A01CHS3E01

      Check the fan and generator V belt deflection.

      Tech Tips

      The specified deflection values per belt are shown in the following table.

      Deflection
      Item Specified Condition
      New belt 10.5 to 12.5 mm (0.41 to 0.49 in.)
      Used belt 12.5 to 16.0 mm (0.49 to 0.63 in.)

      Note


      • Check the V belt deflection at the specified point.

      • When inspecting a belt which has been used for over 5 minutes, apply the used belt specifications.