ENGINE REAR OIL SEAL REMOVAL


  1. REMOVE MANUAL TRANSMISSION ASSEMBLY

    Tech Tips

    Click here

  2. REMOVE CLUTCH COVER ASSEMBLY


    1. A01CI2IE01

      Put matchmarks on the clutch cover assembly and the flywheel sub-assembly.

    2. Loosen each set bolt one turn at a time until spring tension is released.

    3. Remove the set bolts, and pull off the clutch cover assembly.

      Note

      Do not drop the clutch disc assembly.

  3. REMOVE CLUTCH DISC ASSEMBLY

    Note

    Keep the lining part of the clutch disc assembly, the pressure plate and the surface of the flywheel sub-assembly away from oil and foreign matter.

  4. REMOVE FLYWHEEL SUB-ASSEMBLY


    1. A01CHUK

      Uniformly loosen and remove the 6 bolts in the order shown in the illustration.

    2. Remove the flywheel.

      Tech Tips

      Insert a screwdriver through the inspection hole of the flywheel housing into the ring gear of the flywheel to keep it from turning together with the crankshaft.

  5. REMOVE REAR ENGINE OIL SEAL


    1. A01CGP4E01

      Using a knife, cut off the lip of the oil seal.

    2. Using a screwdriver with its tip wrapped in protective tape, pry out the oil seal.