ENGINE FRONT OIL SEAL INSTALLATION


  1. INSTALL TIMING CHAIN OR BELT COVER OIL SEAL


    1. A01CHH5E01

      Using SST and a hammer, tap in a new oil seal to the timing gear case so that the oil seal is flush with the timing gear edge.

      SST
      09223-78010

      Note


      • Be careful not to tap the oil seal at an angle.

      • Keep the gap between the gear case edge and the oil seal free of foreign matter.

    2. Apply MP grease to the oil seal lip.

  2. INSTALL CRANKSHAFT PULLEY


    1. A01CIN3

      Install the pulley and spacer to the crankshaft.

      Tech Tips

      Align the pulley set key with the key groove of the pulley.

    2. Using a 46 mm socket wrench, tighten the nut.

      Torque:
      515 N*m  { 5252 kgf*cm, 380 ft.*lbf }

      Tech Tips

      Insert a screwdriver through the inspection hole of the flywheel housing into the ring gear of the flywheel to keep it from turning together with the crankshaft.

  3. INSTALL RADIATOR ASSEMBLY

    Click here