ECM INSTALLATION


  1. INSTALL NO. 2 ECM BRACKET


    1. Install the No. 2 ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  2. INSTALL NO. 1 ECM BRACKET


    1. Install the No. 1 ECM bracket with the 2 screws.

      Torque:
      3.0 N*m  { 31 kgf*cm, 27 in.*lbf }

  3. INSTALL ECM


    1. Install the ECM to the electric vehicle control ECU assembly with the 2 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

    2. Install the ECM together with the electric vehicle control ECU assembly with the 3 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

      Note

      Do not use an ECM that has been dropped or subjected to a strong impact.

    3. Connect the 3 electric vehicle control ECU assembly connectors.

    4. Connect the 6 ECM connectors.

  4. INSTALL NO. 1 INSTRUMENT PANEL BOX


    1. Attach the 2 wire harness clamps.

    2. Attach the 4 clips, claw and guide to install the No. 1 instrument panel box.

    3. Install the bolt <G>.

  5. INSTALL LOWER INSTRUMENT PANEL


    1. Attach the 8 clips to install the lower instrument panel.

    2. Install the 3 bolts <D>.

    3. Install the clip.

  6. INSTALL LOWER INSTRUMENT COVER


    1. Install the 4 clips to install the lower instrument cover.

  7. INSTALL INSTRUMENT PANEL BOX HOLDER


    1. Install the instrument panel box holder with the 2 screws <E>.

  8. INSTALL INSTRUMENT PANEL BOX ASSEMBLY


    1. Attach the 6 clips to instrument panel box.

  9. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Attach the 13 clips to install the center instrument cluster finish panel sub-assembly.

  10. REGISTER ID CODE

    Click here

  11. CHECK ID CODE

    Click here

  12. INITIALIZE LEARNED VALUE OF SUPPLY PUMP ASSEMBLY


    1. Perform the initialization procedures Click here.

      Note

      Certain systems need to be initialized after reconnecting the cable to the negative (-) battery terminal.