ECD SYSTEM, Diagnostic DTC:P0606, P060A, P060B

DTC Code DTC Name
P0606 ECM / PCM Processor
P060A Internal Control Module Monitoring Processor Performance
P060B Internal Control Module A/D Processing Performance

DESCRIPTION

P0606, P060A, P060B
DTC Detection Drive Pattern DTC Detection Condition Trouble Area
Ignition switch ON for 1 seconds ECM internal error (1 trip detection logic) ECM

INSPECTION PROCEDURE

Note

After replacing the ECM, the new ECM needs registration Click here and initialization Click here.

PROCEDURE


  1. CHECK DTC OUTPUT


    1. Clear the DTCs Click here.

    2. Turn the ignition switch off.

    3. Disconnect the cable from the negative (-) battery terminal and wait for 1 minute.

    4. Connect the negative battery terminal.

    5. Turn the ignition switch to ON.

    6. Enter the following menus: Powertrain / Engine and ECT / DTC.

    7. Read the DTCs.

      Result
      Result Proceed to
      DTC P0606, P060A and/or P060B are output A
      DTC is not output B

    B

    CHECK FOR INTERMITTENT PROBLEMS Click here

    A

    REPLACE ECM Click here