ACCELERATOR PEDAL ROD ON-VEHICLE INSPECTION


  1. INSPECT ACCELERATOR LINK ASSEMBLY


    1. Inspect the voltage.


      1. Connect the intelligent tester to the DLC3.

      2. Turn the ignition switch to ON.

      3. Turn the intelligent tester main switch on.

      4. Enter the menus : Powertrain / Engine and ECT / Data List / Accelerator Position No. 1, Accelerator Position No. 2.

      5. When depressing and releasing the accelerator pedal, check that the values of the accelerator position No. 1 and accelerator position No. 2 are within the specification.

        Accelerator Position No. 1 Standard Voltage
        Condition Specified Condition
        Accelerator pedal is released 0.5 to 1.1 V
        Accelerator pedal is depressed 3.0 to 4.6 V
        Accelerator Position No. 2 Standard Voltage
        Condition Specified Condition
        Accelerator pedal is released 0.9 to 2.3 V
        Accelerator pedal is depressed 3.4 to 5.5 V

        If the result is not as specified, check the accelerator pedal, wire harness, and ECM.