ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE GENERATOR ASSEMBLY

    Click here

  2. DRAIN ENGINE COOLANT

    CAUTION:

    Do not loosen the radiator drain cock plug and engine drain plug while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. A01CIF0E02
      Text in Illustration
      *1 Radiator Cap Sub-assembly
      *2 Radiator Drain Cock Plug
      *3 Engine Drain Plug

      Loosen the radiator drain cock plug and engine drain plug.

    2. Remove the radiator cap sub-assembly, then drain the coolant.

    3. Close the radiator drain cock plug.

    4. Tighten the engine drain plug.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf, for the engine drain plug }

  3. DISCONNECT RADIATOR HOSE INLET


    1. A01CJGQ

      Loosen the 2 clamps, and disconnect the inlet radiator hose and No. 5 radiator hose.

  4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the engine coolant temperature sensor connector.

    2. A01CI2SE01

      Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.