ECD SYSTEM, Diagnostic DTC:P0106

DTC Code DTC Name
P0106 Manifold Absolute Pressure / Barometric Pressure Circuit Range / Performance Problem

DESCRIPTION

By a built-in sensor unit, the turbo pressure sensor (manifold absolute pressure sensor) detects the intake manifold pressure as a voltage. The ECM then determines the basic injection duration and basic ignition advance angle based on this voltage.

Since the turbo pressure sensor does not use the atmospheric pressure as a criterion, but senses the absolute pressure inside the intake manifold (the pressure in proportion to the preset absolute vacuum 0), it is not influenced by fluctuations in the atmospheric pressure due to high altitude and other factors. This permits it to control the air fuel ratio at the proper level under all conditions.

DTC No. DTC Detection Condition Trouble Area
P0106 Voltage output of the manifold absolute pressure sensor is out of the standard range (2 trip detection logic) Turbo pressure sensor

INSPECTION PROCEDURE

Tech Tips

If DTCs P0105, P0107, and P0108 are output simultaneously, the manifold absolute pressure sensor circuit may be open or shorted. Perform troubleshooting for those DTCs first.

PROCEDURE


  1. CHECK OTHER DTC OUTPUT


    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch to the ON position.

    3. Turn the tester on.

    4. Enter the following menu items: Powertrain / Engine and ECT / DTC.

    5. Read the DTCs.

      Result
      Display (DTC output) Proceed to
      P106 A
      P106 and other DTCs B

    B

    GO TO DTC CHART

    A

    REPLACE TURBO PRESSURE SENSOR