ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. REMOVE GENERATOR ASSEMBLY

    Click here

  2. DRAIN ENGINE COOLANT

    CAUTION:

    Do not remove the radiator cap sub-assembly while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.


    1. A01CIF0E01

      Loosen the radiator drain cock plug and engine drain plug.

    2. Remove the radiator cap, then drain the coolant.

    3. Close the radiator drain cock plug.

    4. Tighten the engine drain plug.

      Torque:
      27 N*m  { 275 kgf*cm, 20 ft.*lbf, for the engine drain plug }

  3. DISCONNECT RADIATOR HOSE INLET


    1. A01CHAS

      Loosen the 2 clips and disconnect the radiator hose inlet and No. 5 radiator hose.

  4. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. Disconnect the engine coolant temperature sensor connector.

    2. A01CI2SE01

      Using a 19 mm deep socket wrench, remove the engine coolant temperature sensor and gasket.