DC / DC CONVERTER INSTALLATION

Note

If the voltage converter sub-assembly has been dropped, replace it with a new one.


  1. INSTALL NO. 2 VOLTAGE CONVERTER BRACKET


    1. Install the No. 2 voltage converter bracket to the voltage converter sub-assembly with the 2 screws.

  2. INSTALL VOLTAGE CONVERTER BRACKET


    1. Install the voltage converter bracket to the voltage converter sub-assembly with the 2 screws.

  3. INSTALL ECU BRACKET


    1. Install the ECU bracket with the 3 bolts.

      Torque:
      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

  4. INSTALL VOLTAGE CONVERTER WITH ECU BRACKET


    1. Install the voltage converter with ECU bracket with the 3 bolts.

      Torque:
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf }

    2. Connect the connector.

  5. INSTALL NO. 1 INSTRUMENT PANEL BOX


    1. Attach the 2 wire harness clamps.

    2. Attach the 4 clips, claw and guide to install the No. 1 instrument panel box.

    3. Install the bolt <G>.

  6. INSTALL LOWER INSTRUMENT PANEL


    1. Attach the 8 clips to install the lower instrument panel.

    2. Install the 3 bolts <D>.

    3. Install the clip.

  7. INSTALL LOWER INSTRUMENT COVER


    1. Install the 4 clips to install the lower instrument cover.

  8. INSTALL INSTRUMENT PANEL BOX HOLDER


    1. Install the instrument panel box holder with the 2 screws <E>.

  9. INSTALL INSTRUMENT PANEL BOX ASSEMBLY


    1. Attach the 6 clips to instrument panel box.

  10. INSTALL CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY


    1. Connect each connector.

    2. Attach the 13 clips to install the center instrument cluster finish panel sub-assembly.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.