FRONT AIRBAG SENSOR INSTALLATION


  1. INSTALL NO. 2 AIRBAG SENSOR ASSEMBLY


    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. A01CJ19E01
      Text in Illustration
      *1 Lock Slider
      *2 Airbag Connector (Yellow Colored)
      *3 Guide

      Attach the guide and temporarily install the No. 2 airbag sensor assembly with the bolt.

    4. Tighten the bolt.

      Torque:
      14 N*m  { 138 kgf*cm, 10 ft.*lbf }

      Note


      • If the No. 2 airbag sensor assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.

      • When installing the No. 2 airbag sensor assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.

      • Make sure that the pin (stopper) is securely inserted into the body hole.

      • Tighten the bolt while holding the No. 2 airbag sensor assembly because the No. 2 airbag sensor assembly pin (stopper) is easily damaged.

    5. Connect the airbag connector (yellow colored) to the No. 2 airbag sensor assembly.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    6. Check that the lock slider is in the lock position.

  2. INSTALL WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

    Click here

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  4. PERFORM DIAGNOSTIC SYSTEM CHECK

    Click here

  5. CHECK SRS WARNING LIGHT

    Click here