FRONT AIRBAG SENSOR REMOVAL


  1. PRECAUTION

    CAUTION:

    Be sure to read Precaution thoroughly before servicing Click here.

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE WINDSHIELD WASHER MOTOR AND PUMP ASSEMBLY

    Click here

  4. REMOVE NO. 2 AIRBAG SENSOR ASSEMBLY

    A01CHOLE01
    Text in Illustration
    *1 Lock Slider
    *2 Airbag Connector (Yellow Colored)
    *3 Guide

    1. Check that the ignition switch is off.

    2. Check that the cable is disconnected from the negative (-) battery terminal.

      CAUTION:

      Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    3. Pull the lock slider in the direction indicated by the arrow to release the connector lock and disconnect the airbag connector (yellow colored) from the No. 2 airbag sensor assembly.

      Note

      When handling the airbag connector, take care not to damage the airbag wire harness.

    4. Remove the bolt.

    5. Detach the guide and remove the No. 2 airbag sensor assembly.