N04C-US COMPRESSOR REMOVAL


  1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM


    1. Start up the engine.

    2. A/C switch on.

    3. Turn the blower switch to on.

    4. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the remaining compressor oil from each component, in the cooler compressor.

    5. Stop the engine.

    6. Remove the caps from the service valves on the refrigerant line.

      A01CJ5AE01
      Text in Illustration
      *1 High Pressure Service Valve *2 Low Pressure Service Valve

    7. Connect the refrigerant recovery unit.

    8. Recover the refrigerant from the air conditioning system using a refrigerant recovery unit.

      Tech Tips

      Use the refrigerant recovery unit in accordance with the manufacturer's instruction manual.

  2. REMOVE NO. 1 V (COOLER COMPRESSOR TO CRANKSHAFT PULLEY) BELT

    Click here

  3. DISCONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE


    1. A01CI70

      Remove the bolt and disconnect the No. 1 cooler refrigerant discharge hose from the compressor.

    2. Remove the O-ring from the No. 1 cooler refrigerant discharge hose.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  4. DISCONNECT NO. 2 COOLER REFRIGERANT SUCTION HOSE


    1. A01CIDH

      Remove the bolt and disconnect the No. 2 cooler refrigerant suction hose from the compressor.

    2. Remove the O-ring from the No. 2 cooler refrigerant suction hose.

      Note

      Seal the openings of the disconnected parts using vinyl tape to prevent entry of moisture and foreign matter.

  5. REMOVE COMPRESSOR WITH MAGNET CLUTCH ASSEMBLY


    1. Disconnect the connector.

    2. A01CJ62

      Remove the 4 bolts and the compressor with magnet clutch assembly.