BRAKE ACTUATOR INSTALLATION


  1. INSTALL BRAKE ACTUATOR WITH BRACKET


    1. A01CHRC

      Install the brake actuator with bracket to the body with the 3 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }

      Note

      Do not damage the brake lines or wire harness.

    2. A01CIXLE01

      Temporarily tighten each brake line to the correct positions of the brake actuator with bracket as shown in the illustration.

      Tech Tips


      • *1: To front wheel cylinder RH

      • *2: To front wheel cylinder LH

      • *3: To rear wheel cylinder RH

      • *4: To rear wheel cylinder LH

      • *5: From master cylinder (Rear side)

      • *6: From master cylinder (Front side)

    3. A01CGKXE01

      Using SST, fully tighten the 6 brake lines.

      SST
      09023-00101
      Torque:
      without SST
      15 N*m  { 153 kgf*cm, 11 ft.*lbf }
      with SST
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

      Note


      • Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).

      • This torque value is effective when SST is parallel to a torque wrench.

    4. A01CHSJ

      Connect the brake actuator connector.

      Note

      Make sure that the connector is locked securely.

  2. FILL RESERVOIR WITH BRAKE FLUID

    Tech Tips

    See Pub. No. RM1008E, page 32-4.

  3. BLEED BLAKE LINE

    Tech Tips

    See Pub. No. RM1008E, page 32-4.

  4. INSPECT FOR BRAKE FLUID LEAK

    Tech Tips

    See Pub. No. RM1008E, page 32-4.

  5. INSPECT FLUID LEVEL IN RESERVOIR

    Tech Tips

    See Pub. No. RM1008E, page 32-4.

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  7. INSPECT BRAKE ACTUATOR WITH INTELLIGENT TESTER

    Tech Tips

    Click here.