REAR SPEED SENSOR INSTALLATION


  1. INSTALL REAR SPEED SENSOR


    1. A01CI1HE01

      Install the clamp and rear speed sensor to the axle hub with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note

      Prevent foreign matter from attaching to the sensor tip.

    2. Install the 2 clamps, and rear speed sensor to the differential carrier with the 3 bolts.

      Torque:
      29 N*m  { 296 kgf*cm, 21 ft.*lbf }
      A01CJ36E02

      Note


      • Do not twist the wire harness for the rear speed sensor when installing the speed sensor.

      • Install the rear speed sensor LH and rear speed sensor RH with bolt A.

    3. A01CI03

      Install the rear speed sensor to the frame with the nut and connect the rear speed sensor connectors.

      Torque:
      13 N*m  { 133 kgf*cm, 10 ft.*lbf }

      Note

      Install the rear speed sensor LH and rear speed sensor RH with the nut.

  2. INSTALL REAR WHEEL

    Torque:
    515 N*m  { 5250 kgf*cm, 380 ft.*lbf }

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Click here

  4. CHECK FOR SPEED SENSOR SIGNAL

    Tech Tips

    Click here