FRONT SPEED SENSOR INSTALLATION

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.


  1. INSTALL FRONT SPEED SENSOR


    1. A01CHC9E01
      Text in Illustration
      *a Bolt A
      *b Bolt B

      Install the front speed sensor to the steering knuckle with the 2 bolts.

      Torque:
      Bolt A
      19 N*m  { 194 kgf*cm, 14 ft.*lbf }
      Bolt B
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

      Note


      • Check that the speed sensor tip and installation portion are free of foreign matter.

      • Install the speed sensor without turning it from its original installation angle.

    2. Install the front speed sensor with the nut and bolt.

      Torque:
      31 N*m  { 316 kgf*cm, 23 ft.*lbf }

      Note

      Do not twist the wire harness for the front speed sensor when installing the speed sensor.

    3. Connect the speed sensor connector.

  2. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY LH (for LH Side)

  3. INSTALL ENGINE SIDE COVER SUB-ASSEMBLY RH

  4. CHECK FOR SPEED SENSOR SIGNAL

    Click here