ANTI-LOCK BRAKE SYSTEM TS and CG Terminal Circuit

DESCRIPTION

In the Test Mode (signal check), a malfunction in the speed sensor that cannot be detected when the vehicle is stopped can be detected while driving.

Transition to the sensor check mode can be performed by connecting terminals 12 (TS) and 4 (CG) of the DLC3 and turning the ignition switch from off to ON.

WIRING DIAGRAM

A01CI7TE02

INSPECTION PROCEDURE

PROCEDURE


  1. INSPECT DLC3


    1. A01CGTGE04
      Text in Illustration
      *1 DLC3

      Turn the ignition switch to ON.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Switch Condition Specified Condition
      D34-12 (TS) - D34-4 (CG) Ignition switch ON 11 to 14 V
      Result
      Result Proceed to
      NG A
      OK B

    B

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here

    A

  2. CHECK HARNESS AND CONNECTOR (DLC3 - BRAKE ACTUATOR ASSEMBLY)


    1. Turn the ignition switch off.

    2. Disconnect the B9 skid control ECU (brake actuator assembly) connector.

    3. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D34-12 (TS) - B9-33 (TS) Always Below 1 Ω
      D34-12 (TS) or B9-33 (TS) - Body ground Always 10 kΩ or higher

    4. Reconnect the B9 skid control ECU (brake actuator assembly) connector.


    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

  3. CHECK HARNESS AND CONNECTOR (DLC3 - BODY GROUND)


    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      D34-4 (CG) - Body ground Always Below 1 Ω

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    OK

    REPLACE BRAKE ACTUATOR ASSEMBLY Click here