REAR STABILIZER BAR INSTALLATION


  1. INSTALL REAR STABILIZER BAR


    1. Install the 2 rear stabilizer bushings to the outside of the stoppers on the rear stabilizer bar.

    2. A01CHUXE01
      Text in Illustration
      *a Identification Mark
      *b Cutout
      A01CHW8 Nut
      A01CHIJ Front of the Vehicle

      Install the rear stabilizer bar, 2 rear stabilizer bushings and 2 rear stabilizer brackets with the 4 nuts.

      Torque:
      18 N*m  { 178 kgf*cm, 13 ft.*lbf }

      Note


      • Ensure that the identification mark is on the right side of the vehicle.

      • Be sure to install the rear stabilizer bushings so that each cutout faces the front of the vehicle.

  2. CONNECT REAR STABILIZER BAR (for LH Side)


    1. A01CGKFE01

      Connect the rear stabilizer bar with the rear outer stabilizer end bracket LH, rear inner stabilizer end bracket LH, bolt (A), 2 bolts (B) and 2 washers.

      Torque:
      Bolt (A)
      140 N*m  { 1428 kgf*cm, 103 ft.*lbf }
      Bolt (B)
      76 N*m  { 775 kgf*cm, 56 ft.*lbf }

  3. CONNECT REAR STABILIZER BAR (for RH Side)

    Tech Tips

    Perform the same procedure as the LH side.