FRONT WIPER MOTOR REMOVAL

PROCEDURE


  1. REMOVE FRONT WIPER ARM HEAD CAP


    1. A01VFN3E03
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver with its tip wrapped in protective tape, disengage the 3 claws and remove the front wiper arm head cap.

  2. REMOVE FRONT WIPER ARM AND BLADE ASSEMBLY


    1. A01VK7Z

      Disconnect the washer hose.

    2. A01VLWYE04
      Text in Illustration
      *1 Front Wiper Main Arm

      Remove the nut and the front wiper main arm.

    3. A01VE43E01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the areas shown in the illustration.

    4. A01VJMZE01
      Text in Illustration
      *1 Rope
      *a Head of the Front Wiper Sub Arm

      Twist a rope around the front wiper sub arm at the area shown in the illustration and pull the rope upward to disengage and remove the front wiper arm and blade assembly.

      Note


      • If you forcibly disengage the front wiper sub arm in the incorrect direction, it could be deformed or damaged.

      • If you forcibly pry off the front wiper main arm or front wiper sub arm, the joint section on the end of the front wiper arm could be deformed or damaged.

  3. REMOVE FRONT FENDER TO COWL SIDE SEAL LH


    1. A01VEUBE03
      Text in Illustration
      *1 Double - sided Tape

      Peel off the double - sided tape and disengage the claw and guide.

    2. Disengage the clip and claw and remove the front fender to cowl side seal.

  4. REMOVE FRONT FENDER TO COWL SIDE SEAL RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY


    1. A01VLZ5

      Disconnect the washer hose.

    2. Disengage the 2 clamps.

    3. A01VIV3

      Remove the 2 clips.

    4. Disengage the 5 claws and 3 guides.

    5. Disengage the 9 guides and remove the cowl top ventilator louver.

  6. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY


    1. A01VECP

      Remove the 2 bolts.

    2. Disengage the grommet and remove the windshield wiper motor and link as shown in the illustration.

    3. Disconnect the connector.

  7. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY


    1. A01VEYRE01
      Text in Illustration
      *1 Protective Tape
      *a Windshield Wiper Link Rod
      *b Crank Arm Pivot of the Windshield Wiper Motor Assembly

      Using a screwdriver with its tip wrapped in protective tape, disengage the windshield wiper link rod from the crank arm pivot of the windshield wiper motor as shown in the illustration.

    2. A01VLLY

      Using a T30 "TORX" socket wrench, remove the 2 bolts and the windshield wiper motor from the windshield wiper link.