QUARTER WINDOW GLASS REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE DECK BOARD ASSEMBLY

    Click here

  2. REMOVE SPARE WHEEL COVER

    Click here

  3. REMOVE REAR SEAT ASSEMBLY (for LH Side)

    Click here

  4. REMOVE REAR SEAT ASSEMBLY (for RH Side)

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE

    Tech Tips

    Use the same procedure as for the RH side Click here.

  6. SEPARATE FRONT DOOR OPENING TRIM WEATHERSTRIP

    Tech Tips

    Use the same procedure as for the RH side Click here.

  7. REMOVE FRONT SEAT OUTER BELT BAR SUB-ASSEMBLY

    Tech Tips

    Use the same procedure as for the RH side Click here.

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Tech Tips

    Use the same procedure as for the RH side Click here.

  9. REMOVE CENTER PILLAR UPPER GARNISH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  10. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)

    Click here

  11. REMOVE JACK HANDLE (for RH Side)

  12. REMOVE REAR FLOOR FINISH PLATE

    Click here

  13. SEPARATE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Tech Tips

    Use the same procedure as for the RH side Click here.

  14. REMOVE DECK TRIM SIDE PANEL ASSEMBLY

    Tech Tips

    Use the same procedure as for the RH side Click here.

  15. REMOVE ROOF SIDE INNER GARNISH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  16. REMOVE REAR ROOF SIDE RAIL GARNISH

    Tech Tips

    Use the same procedure as for the RH side Click here.

  17. REMOVE QUARTER WINDOW MOULDING


    1. A01VHM0E02
      Text in Illustration
      *a Cut

      Using a knife, cut off the quarter window moulding, as shown in the illustration.

      Note

      Do not damage the vehicle body with the knife.

      Tech Tips

      Make a partial cut in the quarter window moulding. Then pull and remove it by hand.

  18. REMOVE QUARTER WINDOW GLASS


    1. A01VJPDE01
      Text in Illustration
      *1 Protective Tape

      Apply protective tape to the installation area on the quarter window glass on the vehicle body.

    2. A01VILUE01
      Text in Illustration
      *a Mark

      Place matchmarks on the quarter window glass and vehicle body on the locations indicated in the illustration.

      Tech Tips

      Matchmarks do not need to be placed if the quarter window glass is not going to be reused.

    3. A01VEADE01
      Text in Illustration
      *1 Piano Wire

      Pass a piano wire between the vehicle body and glass from the interior.

    4. Tie both wire ends to wooden blocks or similar objects.

    5. Cut through the adhesive by pulling the piano wire around the quarter window glass.

      Note

      When separating the quarter window glass, take care not to damage the paint or the interior and exterior ornaments.

    6. A01VIM4

      Using suction cups, disengage the 3 clips and remove the quarter window glass.

  19. REMOVE QUARTER WINDOW CLIP


    1. Using a scraper, remove the 3 quarter window clips.

      Note

      Be sure to replace the quarter window clip with a new one.

  20. REMOVE QUARTER WINDOW GLASS SPACER


    1. Using a scraper, remove the 2 quarter window glass spacers.

      Note

      Be sure to replace the quarter window glass spacer with a new one.