B2313

DTC Code	DTC Name
B2313	Glass Position Initialization Incomplete

DESCRIPTION

The front door window regulator assembly LH or RH (driver side) is operated by the power window regulator master switch assembly. The front door window regulator assembly LH or RH (driver side) has motor, regulator and ECU functions.

When the ECU determines that the front door window regulator assembly LH or RH (driver side) has not been initialized, DTC B2313 is set.

DTC No.	DTC Detection Condition	Trouble Area
B2313	Front door window regulator assembly LH or RH (driver side) not initialized Front door window regulator assembly LH or RH (driver side) malfunctions	Front door window regulator assembly LH or RH (driver side) not initialized Front door window regulator assembly LH or RH (driver side) Battery disconnected when ignition switch to ON

Click here

CAUTION / NOTICE / HINT

Note:

When the front door window regulator assembly LH or RH (driver side) is reinstalled or replaced, the power window control system must be initialized.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be resumed by repeating the following operations at least 5 times:
1. Close the power window by fully pulling up the power window regulator master switch assembly and holding it in the auto up position.
2. Open the power window by fully pushing down the power window regulator master switch assembly.

Click here

PROCEDURE

Click here
PERFORM INITIALIZATION (DRIVER SIDE)
1. Initialize the front door window regulator assembly LH or RH (driver side) (Click here).
- NEXTClick here
Click here
CHECK DTC OUTPUT
1. Check for DTCs (Click here).
  
  OK
  
  DTC B2313 is not output.
- OK
  END (POWER WINDOW CONTROL SYSTEM HAS NOT BEEN INITIALIZED)
- NG
  REPLACE FRONT DOOR WINDOW REGULATOR ASSEMBLY LH OR RH (DRIVER SIDE) (Click here)

POWER WINDOW CONTROL SYSTEM, Diagnostic DTC:B2313