INITIALIZE POWER WINDOW CONTROL SYSTEM (FRONT DOOR WINDOW REGULATOR ASSEMBLY LH OR RH (DRIVER SIDE))
CAUTION:
When the front door window regulator assembly LH or RH (driver side) is reinstalled or replaced, the power window control system must be initialized. Functions such as the auto up/down, jam protection, key-off operation do not operate if the initialization is not performed.
Tech Tips
When the battery is replaced, it is not necessary to initialize the front door window regulator assembly.
Note
When the front door window regulator assembly is replaced, DTC B2313 is output. Clear the DTC after the initialization.
When performing initialization, do not perform any other procedures.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used, due to detection of a value different from the operation learned value of the door glass movement speed. In such cases, the auto up function can be reinitialized by repeating the following operation at least 5 times:
Open the power window by fully pushing down the power window regulator master switch assembly.
Close the power window by fully pulling up the power window regulator master switch assembly and holding it at the auto up position.
If the initialization is not completed properly, the LIN communication system may have a malfunction Click here.
Initialization procedure when replacing the front door window regulator assembly with a new one:
Connect the battery and turn the ignition switch to ON.
Fully open the window by fully pushing down the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully opened.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully closed to reset the glass position and complete initialization.
Initialization procedure when removing/installing the front door window regulator assembly:
Connect the battery and turn the ignition switch to ON.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).
Fully open the window by pushing down the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully opened.
Release the power window regulator master switch assembly. Then fully push down and hold the switch for 4 seconds or more.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully closed to reset the glass position and complete the initialization.
Initialization procedure when the power window does not fully open:
Connect the battery and turn the ignition switch to ON.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 6 seconds or more after the window is fully closed (if the power window does not move or stops halfway even when the switch is fully pulled, release the switch and fully pull it again).
Fully open the window by pushing down the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully opened.
Release the power window regulator master switch assembly. Then fully push down and hold the switch for 4 seconds or more.
Fully close the power window by fully pulling up the power window regulator master switch assembly, and hold the switch for 1 second or more after the window is fully closed to reset the glass position and complete the initialization.