FRONT EVAPORATOR TEMPERATURE SENSOR INSTALLATION

PROCEDURE


  1. INSTALL FRONT EVAPORATOR TEMPERATURE SENSOR (NO. 1 COOLER THERMISTOR)


    1. B004764C02
      *1 from Tank
      *2 Fixed Part
      *3 Sensor Part
      *4 Next to Previous
      *5 Plastic Case
      *6 Evaporator

      Install the front evaporator temperature sensor (No. 1 cooler thermistor) as shown in the illustration.

      Installation Position
      Mark Measurement
      a 34.3 mm (1.35 in.)
      b 20.9 mm (0.82 in.)
      c 48 to 52 mm (1.890 to 2.047 in.)

      Note


      • Be sure to insert the sensor only once because reinserting it will not allow it to be firmly secured.

      • When reusing the evaporator, insert the sensor one row next to the one that was used previously (*4 in the illustration).

      • After inserting the sensor, do not apply excessive force to the wire.

      • Directly insert the sensor until the edge of the plastic case "*5" comes into contact with the evaporator "*6".

  2. INSTALL NO. 1 COOLER EVAPORATOR SUB-ASSEMBLY

    Click here

  3. INSTALL COOLER EXPANSION VALVE

    Click here

  4. INSTALL NO. 2 AIR DUCT

    Click here

  5. INSTALL NO. 1 AIR DUCT

    Click here

  6. INSTALL NO. 3 AIR CONDITIONING RADIATOR DAMPER SERVO SUB-ASSEMBLY (for Automatic Air Conditioning System)

    Click here

  7. INSTALL AIR CONDITIONER UNIT ASSEMBLY

    Click here