CONDENSER(for 1ND-TV) INSTALLATION

PROCEDURE

1. INSTALL COOLER CONDENSER ASSEMBLY

   
   

   1. Engage the 2 claws, 2 guides and install the cooler condenser into the vehicle.

      Note

      Do not damage the condenser or radiator when installing the condenser.

      Tech Tips

      If a new cooler condenser is installed, add compressor oil to the condenser as follows.

      Capacity
      Add 40 cc (1.35 fl. oz.)

      Compressor oil
      ND-OIL8 or equivalent.

2. CONNECT LIQUID TUBE SUB-ASSEMBLY B

   
   

   1. Remove the attached vinyl tape from the tube and the connecting part of the cooler condenser.

   2. Apply sufficient compressor oil to a new O-ring and the fitting surface of the tube joint.

      Compressor oil
      ND-OIL8 or equivalent.

   3. Install the O-ring onto the liquid tube.

   4. Install the liquid tube onto the cooler condenser with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

3. CONNECT NO. 1 COOLER REFRIGERANT DISCHARGE HOSE

   
   

   1. Remove the attached vinyl tape from the hose and the connecting part of the cooler condenser.

   2. Apply sufficient compressor oil to a new O-ring and the fitting surface of the hose joint.

      Compressor oil
      ND-OIL8 or equivalent

   3. Install the O-ring onto the discharge hose.

   4. Install the discharge hose onto the cooler condenser with the bolt.

      Torque:

      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

4. INSTALL NO. 1 RADIATOR SIDE AIR SEAL

   Tech Tips

   Use the same procedure as for the No. 2 side Click here.

5. INSTALL RADIATOR UPPER SUPPORT SUB-ASSEMBLY

   
   

   1. Install the 4 bolts and the radiator upper support.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Engage the clamp and install the hood lock control cable.

   3. Engage the 2 clamps and install the wire harness.

   4. Connect the connector.

6. INSTALL FRONT AIRBAG SENSOR

   Click here

7. INSTALL HEADLIGHT ASSEMBLY LH

   Click here

8. INSTALL HEADLIGHT ASSEMBLY RH

   Tech Tips

   Use the same procedure as for the LH side.

9. CHARGE REFRIGERANT

   Click here

10. WARM UP ENGINE

    Click here

11. INSPECT FOR REFRIGERANT LEAK

    Click here

12. PREPARE VEHICLE FOR HEADLIGHT AIMING ADJUSTMENT

    Click here

13. PREPARE FOR HEADLIGHT AIMING

    Click here

14. INSPECT HEADLIGHT AIMING

    Click here

15. ADJUST HEADLIGHT AIMING

    Click here