REAR CENTER SEAT OUTER BELT ASSEMBLY INSTALLATION

PROCEDURE

1. INSTALL REAR CENTER SEAT OUTER BELT ASSEMBLY

   
   
   1. 

      Text in Illustration

      *a	Lock
      *b	Unlock

      Check the angle of inclination required to lock the retractor.

      
      

      1. Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.

         Note

         Do not disassemble the retractor.

         If the operation is not as specified, replace the rear center seat outer belt assembly.

   2. Engage the 2 hooks to install the rear center seat outer belt assembly.

   3. Install the bolt.

      Torque:

      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

   4. Connect the shoulder anchor with the bolt.

      Torque:

      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

   5. Check that the ELR locks.

      Note

      Perform the check with the rear center seat outer belt assembly installed.

      
      

      1. With the belt installed, check that the belt locks when it is pulled out quickly.

         If the operation is not as specified, replace the rear center seat outer belt assembly.

   6. Loosen the bolt to disconnect the shoulder anchor.

2. INSTALL REAR SEAT SHOULDER BELT COVER

   Click here

3. INSTALL ROOF HEADLINING ASSEMBLY (for TMMF Made 3 Door)

   Click here

4. INSTALL ROOF HEADLINING ASSEMBLY (for TMMF Made 5 Door)

   Click here