CAUTION / NOTICE / HINT
The procedure described below is for the RH side. Use the same procedure for both the LH and RH sides, unless otherwise specified.
PROCEDURE
INSTALL REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
Check the angle of inclination required to lock the retractor.
Gently incline the retractor from its initial position. Check that the belt does not lock when the retractor is inclined 15° or less in any direction. Also, check that the belt locks when the inclination of the retractor is 45° or more.
Do not disassemble the retractor.
If the operation is not as specified, replace the rear seat 3 point type outer belt assembly.
Engage the 2 hooks to install the rear seat 3 point type outer belt assembly.
Install the bolt.
| 41 N*m | 420 kgf*cm | 30 ft.*lbf |
Install the floor anchor with the bolt.
| 41 N*m | 420 kgf*cm | 30 ft.*lbf |
Check that the ELR locks.
Perform the check with the rear seat 3 point type outer belt assembly installed.
With the belt installed, check that the belt locks when it is pulled out quickly.
If the operation is not as specified, replace the rear seat 3 point type outer belt assembly.
INSTALL ROOF SIDE INNER GARNISH
INSTALL DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)
INSTALL DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)
CONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY
INSTALL FRONT QUARTER TRIM PANEL ASSEMBLY
INSTALL FRONT SEAT BELT OUTER BAR SUB-ASSEMBLY
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
INSTALL FRONT DOOR SCUFF PLATE
INSTALL REAR FLOOR FINISH PLATE
INSTALL JACK HANDLE (for RH Side)
INSTALL NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)
INSTALL SPARE WHEEL COVER
INSTALL DECK BOARD ASSEMBLY
INSTALL REAR SEAT ASSEMBLY (for RH Side)
INSTALL REAR SEAT ASSEMBLY (for LH Side)