REAR SEAT OUTER BELT ASSEMBLY(for 5 Door) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR SEAT ASSEMBLY (for LH Side)

    Click here

  2. REMOVE REAR SEAT ASSEMBLY (for RH Side)

    Click here

  3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  4. REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  5. REMOVE SPARE WHEEL COVER (w/ Cover)

    Click here

  6. REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)

    Click here

  7. REMOVE JACK HANDLE (for RH Side)

  8. REMOVE REAR FLOOR FINISH PLATE

    Click here

  9. REMOVE REAR DOOR SCUFF PLATE

    Click here

  10. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the rear door opening trim weatherstrip.

  11. DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Click here

  12. REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Click here

  13. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    Click here

  14. REMOVE ROOF SIDE INNER GARNISH

    Click here

  15. REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    1. B0046UP

      Remove the bolt to disconnect the shoulder anchor part of the rear seat 3 point type outer belt assembly.

    2. B0045B2C01
      *a Protective Tape
      *b Locking Button

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    3. Disconnect the pretensioner connector.

    4. B00459L

      Remove the 2 bolts.

    5. Disengage the 2 hooks to remove the rear seat 3 point type outer belt assembly.