FRONT SEAT OUTER BELT ASSEMBLY(for 3 Door) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  3. REMOVE REAR SEAT ASSEMBLY (for LH Side)

    Click here

  4. REMOVE REAR SEAT ASSEMBLY (for RH Side)

    Click here

  5. REMOVE FRONT DOOR SCUFF PLATE

    Click here

  6. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  7. DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY


    1. A0047UN

      Disengage the 3 claws to remove the lap belt outer anchor cover.

    2. A0047EN

      Remove the bolt to disconnect the floor anchor part of the front seat outer belt assembly.

  8. REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

  9. REMOVE CENTER PILLAR UPPER GARNISH

    Click here

  10. REMOVE FRONT SEAT OUTER BELT ASSEMBLY


    1. A0049J3

      Remove the bolt and disconnect the shoulder anchor part of the front seat outer belt assembly.

    2. A004BJSC01
      *a Protective Tape
      *b Locking Button

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    3. Disconnect the pretensioner connector.

    4. A0047Z2

      Remove the 2 bolts.

    5. Disengage the 2 hooks to remove the front seat outer belt assembly.