Click here

REAR SEAT OUTER BELT ASSEMBLY(for 3 Door) REMOVAL

Click here
Click here Click here

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing (Click here).

Tip:

  • Use the same procedure for the RH and LH side.

  • The procedure listed below is for the LH side.

Click here

PROCEDURE


  1. Click here

    PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).

  2. Click here

    DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

  3. Click here

    REMOVE REAR SEAT ASSEMBLY (for LH Side)

    (Click here)

  4. Click here

    REMOVE REAR SEAT ASSEMBLY (for RH Side)

    (Click here)

  5. Click here

    REMOVE DECK BOARD ASSEMBLY (w/ Deck Board)

    Click here

  6. Click here

    REMOVE SPARE WHEEL COVER (w/ Cover)

    Click here

  7. Click here

    REMOVE NO. 2 ROOM LIGHT ASSEMBLY (for LH Side)

    Click here

  8. Click here

    REMOVE JACK HANDLE (for RH Side)

  9. Click here

    REMOVE REAR FLOOR FINISH PLATE

    Click here

  10. Click here

    REMOVE FRONT DOOR SCUFF PLATE

    Click here

  11. Click here

    DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP


    1. Disconnect the front door opening trim weatherstrip.

  12. Click here

    DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY

    Click here

  13. Click here

    REMOVE FRONT QUARTER TRIM PANEL ASSEMBLY

    Click here

  14. Click here

    DISCONNECT REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY

    Click here

  15. Click here

    REMOVE DECK TRIM SIDE PANEL ASSEMBLY RH (for RH Side)

    Click here

  16. Click here

    REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH (for LH Side)

    Click here

  17. Click here

    REMOVE ROOF SIDE INNER GARNISH

    Click here

  18. Click here

    REMOVE REAR SEAT 3 POINT TYPE OUTER BELT ASSEMBLY


    1. A0048IW

      Remove the bolt and shoulder anchor.

    2. A004AH3C01
      *a Protective Tape
      *b Locking Button

      Using a screwdriver with its tip wrapped in protective tape, release the locking button.

    3. Disconnect the pretensioner connector.

    4. A004A9V

      Remove the 2 bolts.

    5. Disengage the 2 hooks to remove the rear seat 3 point type outer belt assembly.