FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips

The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.

PROCEDURE


  1. INSTALL FRONT SEAT INNER BELT ASSEMBLY

    A01VDU2E01
    Text in Illustration
    *a Convex

    1. Install the front seat inner belt assembly with the bolt.

      Torque:
      41 N*m  { 420 kgf*cm, 30 ft.*lbf }

      Note

      Do not place the front seat inner belt over the convex areas of the front seat with frame adjuster.

    2. Engage the 2 clamps.

    3. Install the 5 clamps. (w/o Seat Heater System)

    4. Connect the seat heater connector. (w/ Seat Heater System)

    5. Install the 5 clamps. (w/ Seat Heater System)

  2. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Click here

  3. INSTALL FRONT SEAT ASSEMBLY (for 5 Door)

    Click here

  4. INSTALL FRONT SEAT ASSEMBLY (for 3 Door)

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  6. INSPECT SRS WARNING LIGHT

    Click here