FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips

The procedure described below is for the LHD. Use the same procedure for both RHD and LHD, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE FRONT SEAT ASSEMBLY (for 5 Door)

    Click here

  4. REMOVE FRONT SEAT ASSEMBLY (for 3 Door)

    Click here

  5. REMOVE FRONT SEAT CUSHION COVER (except GRMN)

    Click here

  6. REMOVE FRONT SEAT INNER BELT ASSEMBLY


    1. w/o Seat Heater System:


      1. B0046SN

        Disengage the 5 clamps.

    2. w/ Seat Heater System:


      1. B0045XU

        Disengage the 5 clamps.

      2. Disconnect the seat heater connector.

    3. B004670

      Remove the wire harness from the 2 clamps of the front seat cushion shield.

    4. Remove the bolt and the front seat inner belt assembly.