OCCUPANT DETECTION SENSOR(for 3 Door) REMOVAL
CAUTION / NOTICE / HINT
CAUTION:
-
Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.
-
Wear protective gloves. Sharp areas on the parts may injure your hands.
Note
Always use "TORX" socket wrench E10 when removing the front seat.
Tech Tips
-
Use the same procedure for RHD and LHD vehicles.
-
The procedure listed below is for LHD vehicles.
PROCEDURE
-
PRECAUTION
Note
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.
-
DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
-
REMOVE SEAT TRACK OUTER COVER
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE FRONT SEAT ASSEMBLY
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE RECLINING ADJUSTER RELEASE HANDLE
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE FRONT SEAT CUSHION SHIELD
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE FRONT SEAT CUSHION COVER (for LHD)
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE FRONT SEAT INNER BELT ASSEMBLY
-
REMOVE FRONT SEAT CUSHION INNER SHIELD
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Tech Tips
Use the same procedure as for the LH side Click here.
-
REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD
-
Disengage the 15 hooks and remove the separate type front seat cushion cover from the separate type front seat cushion pad (occupant detection sensor).
-