OCCUPANT DETECTION SENSOR(for 5 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use E10 "TORX" socket wrench when removing the front seat.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (for TMMF Made)


    1. Engage the 15 hooks to install the separate type front seat cushion cover to the separate type front seat cushion pad (occupant detection sensor).

  2. INSTALL SEPARATE TYPE FRONT SEAT CUSHION PAD (for TMC Made)


    1. Temporarily install the separate type front seat cushion cover.

    2. B0045VHE01
      Text in Illustration
      *1 Hog Ring
      *2 Hog Ring Pliers

      Using hog ring pliers, install 14 new hog rings.

      Note


      • Be careful not to damage the separate type front seat cushion cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

      • Align the center of the hog ring installation area of the separate type front seat cushion cover with the center of the separate type front seat cushion pad so that no wrinkles appear, and securely tighten the hog rings as shown in the illustration.

    3. B0045PWE01
      Text in Illustration
      *1 Hog Ring
      *2 Hog Ring Pliers

      Using hog ring pliers, install the separate type front seat cushion cover to the separate type front seat cushion pad with 2 new hog rings.

      Note


      • Be careful not to damage the separate type front seat cushion cover.

      • When installing the hog rings, take care to minimize wrinkles as much as possible.

      • Securely tighten the hog rings as shown in the illustration.

  3. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Tech Tips

    Use the same procedure as for the LH side Click here.

  4. INSTALL FRONT SEAT INNER BELT ASSEMBLY

    Click here

  5. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Tech Tips

    Use the same procedure as for the LH side Click here.

  6. INSTALL FRONT SEAT CUSHION INNER SHIELD

    Tech Tips

    Use the same procedure as for the LH side Click here.

  7. INSTALL FRONT SEAT CUSHION SHIELD

    Tech Tips

    Use the same procedure as for the LH side Click here.

  8. INSTALL RECLINING ADJUSTER RELEASE HANDLE

    Tech Tips

    Use the same procedure as for the LH side Click here.

  9. INSTALL FRONT SEAT ASSEMBLY

    Tech Tips

    Use the same procedure as for the LH side Click here.

  10. INSTALL SEAT TRACK OUTER COVER

    Tech Tips

    Use the same procedure as for the LH side Click here.

  11. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  12. INSPECT SRS WARNING LIGHT

    Click here