FRONT SEAT CUSHION HEATER(for 3 Door) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. INSTALL SEPARATE TYPE FRONT SEAT CUSHION COVER


    1. Engage the 15 hooks to install the separate type front seat cushion cover (front seat cushion heater) to the separate type front seat cushion pad.

  2. INSTALL SEAT CUSHION COVER WITH PAD

    Click here

  3. INSTALL FRONT SEAT CUSHION INNER SHIELD LH

    Click here

  4. INSTALL FRONT SEAT INNER BELT ASSEMBLY LH (for Driver Side)

    Click here

  5. INSTALL FRONT SEAT INNER BELT ASSEMBLY RH (for Front Passenger Side)

    Click here

  6. INSTALL FRONT SEAT CUSHION COVER (for LHD)

    Click here

  7. INSTALL FRONT SEAT CUSHION SHIELD LH

    Click here

  8. INSTALL VERTICAL ADJUSTING HANDLE LH (for Driver Side)

    Click here

  9. INSTALL NO. 1 RECLINING ADJUSTER RELEASE HANDLE LH

    Click here

  10. INSTALL FRONT SEAT ASSEMBLY LH

    Click here

  11. INSTALL SEAT TRACK COVER OUTER LH

    Click here

  12. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

  13. INSPECT SRS WARNING LIGHT

    Click here