FRONT SEAT INNER BELT ASSEMBLY(for Driver Side) INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

Note

Always use E10 "TORX" socket wrench when removing the front seat.

Tech Tips

The procedure described below is for the LHD. Use the same procedure for both the RHD and LHD, unless otherwise specified.

PROCEDURE


  1. INSTALL FRONT SEAT INNER BELT ASSEMBLY

    B00483WE01
    Text in Illustration
    *a Convex

    1. Install the front seat inner belt assembly with the nut.

      Torque:
      42 N*m  { 428 kgf*cm, 31 ft.*lbf }

      Note

      Do not place the front seat inner belt assembly over the convex areas of the separate type front seat cushion spring assembly.

    2. Engage the 2 clamps.

    3. w/o Seat Heater System:


      1. Install the 5 clamps.

    4. w/ Seat Heater System:


      1. Connect the seat heater connector.

      2. Install the 5 clamps.

  2. INSTALL FRONT SEAT CUSHION COVER (except GRMN)

    Click here

  3. INSTALL FRONT SEAT ASSEMBLY (for 5 Door)

    Click here

  4. INSTALL FRONT SEAT ASSEMBLY (for 3 Door)

    Click here

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Torque:
    5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here