FRONT SEAT ASSEMBLY(for 3 Door GRMN) REMOVAL

CAUTION / NOTICE / HINT

CAUTION:


  • Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing Click here.

  • If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback with cover pad with a new one.

Note

Always use "TORX" socket wrench E10 when removing the front seat.

Tech Tips


  • The procedure described below is for the LHD side. Use the same procedure for both the LHD and RHD side, unless otherwise specified.

  • The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE SEAT TRACK OUTER COVER LH (for Driver Side)


    1. Move the seat to the foremost position.

    2. B0045FA

      Disengage the guide and 2 claws to remove the seat track outer cover LH.

  4. REMOVE SEAT TRACK OUTER COVER RH (for Front Passenger Side)

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE FRONT SEAT ASSEMBLY LH


    1. Disconnect the buckle switch connector.

    2. Disconnect the front seat side airbag connector.

      B0047SCE02
      Text in Illustration
      *1 Slider - -

      1. Place a finger on the slider, slide the slider to release the lock, and then disconnect the front seat side airbag connector.

    3. B00480S

      Using E10 "TORX" socket wrench, remove the 2 bolts on the rear side of the seat.

    4. Move the seat to the rearmost position.

    5. Using E10 "TORX" socket wrench, remove the 2 bolts on the front side of the seat.

    6. for Driver Side:


      1. Lift up the seat track adjusting handle.

    7. Remove the front seat assembly LH.

      Note

      Be careful not to damage the vehicle body.

  6. REMOVE FRONT SEAT ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.